top of page
Search
  • David Pionk

Shaft Torsion Tester

A customer needed a gage machine programmed using Siemens as requested by their customer. They had brought me in for the controls design/programming/installation of a system capable of measuring the degree angle of flange welded onto a shaft. The flange needed to be non-destructive tested for integrity and measured again for deviation within a tolerance. This project uses a load cell on the end of a servo driven linear actuator to apply a force on the flange. A Keyence GT2 air actuated touch probe is used for measuring the degrees of rotation of the flange in relation to the shaft.





19 views0 comments

Recent Posts

See All
bottom of page